- Notes, cautions, and warnings
- Working on your computer
- Removing and
installing components
- Recommended tools
- Screw size list
- Subscriber Identification Module (SIM) card
- Base cover
- Battery
- PCIe Solid State Drive (SSD)
- SATA Solid State Drive (SSD)
- Speaker
- Coin cell battery
- WWAN card
- WLAN card
- Memory module
- Heat sink
- Power connector port
- LED board
- Smart card module
- Touchpad buttons board
- Display Assembly
- Display hinge cap
- System board
- Keyboard assembly
- Keyboard
- Palm rest
- Technology and components
- Software
- System specifications
- Processor specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Battery specifications
- AC adapter specifications
- Port and connector specifications
- Communication specifications
- Touchpad specifications
- Camera specifications
- Display
- Dimensions and Weight
- Environmental specifications
- System setup
- Boot menu
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS in Windows
- Updating your system BIOS using a USB flash drive
- System and setup password
- Troubleshooting
Dell Latitude 7380 Owner's Manual
Installing LED board
- Insert the LED board into the slot on the computer.
- Tighten the M2.0 x 2.5screw to secure the LED board.
- Route the LED cable through the routing channel.
- Connect the LED cable to the LED board.
- Install the base cover.
- Follow the procedure in After working inside your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\